How to Reset a Motorola Baby Monitor?

If you have a Motorola baby monitor, you may find that it becomes very hard for you to reset the device when it loses connectivity, especially with the best baby monitors for twins, as this set of devices could be complicated. This usually happens after long use. Sometimes, it also happens if your child stops communicating with you. You will then have to reset the device to get back to what you were doing before. Here are some instructions that will help you do it.

If you are using the Motorola Mango, then you need to power it up. Once it turns on, you can then go about resetting it. You need to do this by unplugging the phone from the USB connector. Next, you need to turn it on under any circumstance to make sure that it is awake. Then, you need to press and hold the power key.

When you are talking to your child through the baby monitor, you should consider turning off the volume so as to prevent the signal from being interrupted. After this, you should connect the audio cable to the wall outlet. Next, you need to follow the on screen instructions carefully so as to learn how to reset Motorola baby monitor. Then, you need to follow each step carefully in order to complete the process properly.

First of all, you need to turn on the modem. It is important to make sure that you do this step correctly. Then, you need to enter the access code given on your phone. This is usually 6 digits. After entering the code, you should reboot your phone.

Secondly, you should turn on your Motorola baby monitor by plugging in the cord. You should find a reset switch right next to the power jack. You need to push down the reset switch in order to open up the cover. Finally, you need to remove the cover using the screwdriver. The reset switch controls the power to the cord.

Thirdly, you should insert the new cable into the Motorola baby monitor. Then, you need to turn on the power button on the switch. After this, you can remove the battery very carefully. Once you have done this task, you should push down the main switches and connectors in order to release the battery.

Fourthly, you should plug in the USB cord. Then, you can turn on the power button on the switch. Once you have done this step, you need to press the power cord to the Motorola baby monitor to plug in the cord. Finally, you should turn on the ignition. If you have done it correctly, you should hear the beep of your cord.

Fifthly, you should insert the reset switch in between the power jack and the Motorola baby monitor cord. Then, you should push down the switch in order to open the cover. Finally, you need to remove the cover very gently. It is possible that you might have to deal with some resistance as well. If this occurs, you should consider using some kind of tool to make the connection between the cord and the switch firm.

Sixthly, you should remove the three screws located at the bottom of the cord. This will enable you to remove the Motorola phone cable safely. Then, you should insert the new baby monitor cable into the old outlet. However, you need to ensure that the three screws are not reversed before inserting the new cable. You will know when you have successfully completed this step.

Seventhly, you should turn on the phone. Then, you need to hold the home key on the virtual keypad. This will help you to enter the five-digit code on the Motorola phone. If you do it correctly, you will hear a beep.

Eighthly, you should put the phone onto the back of your knees. Then, you should hold the home key on the virtual keypad. This will help you to enter the five-digit code on the Motorola phone. If you do it correctly, you will hear a beep.

Finally, you should put the two Motorola dongles into the adapter. After this, you should put the new outlet into the cord. After that, you should plug in the cord into the new outlet. Finally, you should test the cord for a few seconds and then replace it.

Leave a Comment